802.11 a/b/g 200mW miniPCI radio with 54/108 Mbps support|
||wlm54sag23 = Compex WLM54SAG 23dB radio card, RoHS compliant
||u.fl, compatible with PC Engines I-PEX pigtail cables. Pigtail and antenna
must be ordered separately.
||Must use WRAP BIOS 1.11 or later to use Atheros single chip solutions.
Old BIOS does not keep PCI reset active long enough.
||Wireless radio cards are ESD sensitive, especially the RF switch and the
power amplifier. To avoid damage by electrostatic discharge,
the following installation procedure is recommended:
- Touch your hands and the bag containing the radio card to a ground
point on the router board (for example one of the mounting holes). This
will equalize the potential of radio card and router board.
- Install the radio card in the miniPCI socket.
- Install the pigtail cable in the cutout of the enclosure. This will
ground the pigtail to the enclosure.
- Touch the I-PEX connector of the pigtail to the mounting hole
(discharge), then plug onto the radio card.
- Use external lightning protection for outdoor applications.
||These cards are intended for professional use, not end-user installation.
Country code is set to
0 (universal), please make sure that your AP software sets the correct
locale to ensure correct frequency and power settings.
|© 2002-2016 PC Engines GmbH. All rights reserved.|